mycnc:height_mapping
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
mycnc:height_mapping [2023/12/07 09:55] – ivan | mycnc:height_mapping [2024/03/22 14:12] (current) – ivan | ||
---|---|---|---|
Line 32: | Line 32: | ||
* Press the Run button (this begins the probing process) | * Press the Run button (this begins the probing process) | ||
{{: | {{: | ||
- | * After the probing program has completed running, press the Apply Map button. The original G-code file that you have loaded in should now be corrected. | + | * After the probing program has completed running, press the Refresh button in the top ribbon. |
+ | * After refreshing the G-code file, press the Apply Map button. The original G-code file that you have loaded in should now be corrected. | ||
{{: | {{: | ||
* After the file has been corrected for surface level imperfections, | * After the file has been corrected for surface level imperfections, |
mycnc/height_mapping.txt · Last modified: 2024/03/22 14:12 by ivan