Differences

This shows you the differences between two versions of the page.

--- quickstart:mycnc-quick-start:probe_setup [2019/07/04 10:13] – ivan
+++ quickstart:mycnc-quick-start:probe_setup [2019/07/04 10:22] – ivan
@@ Line 1: / Line 1: @@
 =====Setting up the probe tool=====
-This manual covers the basic setup of the probe tool that can be used in a number of myCNC profiles and applications in order to determine an exact position of the part on a milling machine. The probe can find edges, corners, hole centers, and more.
+The probe tool is currently being sold as part of some myCNC kits. The main sensor looks like the image below:
+{{:quickstart:mycnc-quick-start:vers-pr-render-s-001.jpg}}
+This manual covers the basic setup of the probe that can be used in a number of myCNC profiles and applications in order to determine an exact position of the part on a milling machine. The probe can find edges, corners, hole centers, and more.
 ====Calibration/Adjustment of the probe sensor====
@@ Line 21: / Line 25: @@
 ====Connection to the myCNC board====
-A Vers PR probe is currently being sold as part of some myCNC kits. The sensor looks like the image below:
-{{:quickstart:mycnc-quick-start:probe-sensor-physical-001.jpg}}
 In order to set up this probe sensor with a myCNC controller, please consult the diagrams below. Note that while the setup is shown in one particular configuration on the ET7 myCNC control board, it can be replicated on other boards and in other connection configurations as well: