quickstart:mycnc-control-board-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
quickstart:mycnc-control-board-setup [2019/09/23 10:41] – ivan | quickstart:mycnc-control-board-setup [2021/08/04 14:19] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
=====Setting up the myCNC control board===== | =====Setting up the myCNC control board===== | ||
- | This is the general setup process for myCNC control boards. Please consult the manuals for specific boards on pinout configurations, | + | This is the general setup process for myCNC control boards. Please consult the manuals for specific boards on pinout configurations, |
====Power and Network==== | ====Power and Network==== | ||
Line 29: | Line 29: | ||
====Pulse Width==== | ====Pulse Width==== | ||
+ | |||
+ | {{youtube> | ||
+ | |||
* Check what minimal pulse width your drivers accept and set pulse width of myCNC control board accordingly (equal or more) in MyCNC software -> Cfg Settings -> Hardware Tab -> Common Hardware Settings {{mycnc: | * Check what minimal pulse width your drivers accept and set pulse width of myCNC control board accordingly (equal or more) in MyCNC software -> Cfg Settings -> Hardware Tab -> Common Hardware Settings {{mycnc: | ||
* Read more about the pulse width setup [[mycnc: | * Read more about the pulse width setup [[mycnc: |
quickstart/mycnc-control-board-setup.txt · Last modified: 2024/01/25 11:44 by ivan