quickstart:mycnc-control-board-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
quickstart:mycnc-control-board-setup [2019/09/23 10:40] – ivan | quickstart:mycnc-control-board-setup [2024/01/25 11:44] (current) – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
=====Setting up the myCNC control board===== | =====Setting up the myCNC control board===== | ||
- | This is the general setup process for myCNC control boards. | + | This is the general setup process for myCNC control boards. Please consult the manuals for specific boards on pinout configurations, |
====Power and Network==== | ====Power and Network==== | ||
Line 8: | Line 8: | ||
* Here are power-up examples for ET6, ET7, ET10 control boards: [[mycnc: | * Here are power-up examples for ET6, ET7, ET10 control boards: [[mycnc: | ||
* Connect myCNC Ethernet controller with Network cable directly to Host computer or to Network Router. If use Odroid-C2 (Raspberry-Pi3) computers as a Host, Network cable is a short 0.5ft cable between Odroid & Controller {{mycnc: | * Connect myCNC Ethernet controller with Network cable directly to Host computer or to Network Router. If use Odroid-C2 (Raspberry-Pi3) computers as a Host, Network cable is a short 0.5ft cable between Odroid & Controller {{mycnc: | ||
- | * Setup Network addresses for Host computer and myCNC Ethernet controller. Addresses of Controller and Host should be in same local network. For Example - < | + | * Setup Network addresses for Host computer and myCNC Ethernet controller. Addresses of Controller and Host should be in same local network. For Example - < |
- | Host Address: 192.168.0.100</ | + | Host Address: 192.168.4.100</ |
Host Address: 192.168.5.11</ | Host Address: 192.168.5.11</ | ||
* Goto MyCNC software, Cfg Settings, Network Tab and | * Goto MyCNC software, Cfg Settings, Network Tab and | ||
Line 29: | Line 29: | ||
====Pulse Width==== | ====Pulse Width==== | ||
+ | |||
+ | {{youtube> | ||
+ | |||
* Check what minimal pulse width your drivers accept and set pulse width of myCNC control board accordingly (equal or more) in MyCNC software -> Cfg Settings -> Hardware Tab -> Common Hardware Settings {{mycnc: | * Check what minimal pulse width your drivers accept and set pulse width of myCNC control board accordingly (equal or more) in MyCNC software -> Cfg Settings -> Hardware Tab -> Common Hardware Settings {{mycnc: | ||
* Read more about the pulse width setup [[mycnc: | * Read more about the pulse width setup [[mycnc: |
quickstart/mycnc-control-board-setup.txt · Last modified: 2024/01/25 11:44 by ivan