Differences

This shows you the differences between two versions of the page.

--- mycnc:sbc [2018/09/06 13:23] – skirillov
+++ mycnc:sbc [2018/10/10 23:32] (current) – skirillov
@@ Line 10: / Line 10: @@
-==== Single Board Computer (SBC) perfofmance issue ====
+==== Single Board Computer (SBC) performance issue ====
 We have found an issue with OpenGL-ES driver implementation for single board computers (Tinker Board, Odroid-C2 etc).
@@ Line 24: / Line 24: @@
-This CPU overloading might lead to CPU overheat, keyboard event delays, job stope (due to command buffer feed lags in the controller) and other system faults.
+This CPU overloading might lead to CPU overheat, keyboard event delays, job stops (due to command buffer feed lags in the controller) and other system faults.
-To test what is the reason ob CPU overloading we added "Disable Cursor" checkbox in 3D visualisation setting.
+To test what is the reason of CPU overloading we added "Disable Cursor" checkbox in 3D visualisation setting.
 {{mycnc:opengl:mycnc-disable-cursor.png}}
@@ Line 32: / Line 32: @@
 If this checkbox is checked, the visualisation widget ignores position messages from the myCNC controller, does not update new work position on visualisation widget (a red cursor) and does not refresh a complete scene.
-The result is shown in a screenshot below. CPU loading drops about 5 times. Only 1 core is loaded to 40%, the rest cores are loaded less. myCNC takes only 30% from one core, the rest is taken by the Linux system.
+The result is shown in a screenshot below. CPU loading drops about 5 times. Only 1 core is loaded to 40%, the rest cores are loaded less. myCNC loads just 1 core mostly, the rest is taken by the Linux system.