mycnc:open_collector_outputs_and_pwm_outputs_schematic_design
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:open_collector_outputs_and_pwm_outputs_schematic_design [2017/07/17 12:05] – skirillov | mycnc:open_collector_outputs_and_pwm_outputs_schematic_design [2017/07/17 12:06] – skirillov | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| To test output pins load resistor should be connected between output pin and +24V. Oscilloscope diagrams for PWM are shown below - | To test output pins load resistor should be connected between output pin and +24V. Oscilloscope diagrams for PWM are shown below - | ||
| PWM=20 {{hardware: | PWM=20 {{hardware: | ||
| - | + | PWM=500 {{hardware:mycnc-pwm-output-0500.png}} | |
| - | PWM=500 {{mycnc-pwm-output-0500.png}} | + | PWM=2000 {{hardware:mycnc-pwm-output-1000.png}} |
| - | + | PWM=2000 {{hardware:mycnc-pwm-output-2000.png}} | |
| - | PWM=2000 {{mycnc-pwm-output-1000.png}} | + | PWM=3000 {{hardware:mycnc-pwm-output-3000.png}} |
| - | + | PWM=3980 {{hardware:mycnc-pwm-output-3980.png}} | |
| - | PWM=2000 {{mycnc-pwm-output-2000.png}} | + | |
| - | + | ||
| - | PWM=3000 {{mycnc-pwm-output-3000.png}} | + | |
| - | + | ||
| - | PWM=3980 {{mycnc-pwm-output-3980.png}} | + | |
mycnc/open_collector_outputs_and_pwm_outputs_schematic_design.txt · Last modified: 2017/07/17 13:16 by skirillov