User Tools

Site Tools


mycnc:open_collector_outputs_and_pwm_outputs_schematic_design

Controller boards ET6, ET7, ET10 (breakout) have similar schematic design for outputs and binary outputs. It is standard open collector schematic. Darlington transistor array chip ULN2003 is used to drive outputs pins. According to ULN2003 datasheet transistors can drive up to 500mA current, however we recommend do not exceed 250mA.

Schematic is shown below -

There are 12 bit counter to program PWM outputs, PWM min value is “0”, PWM max value is “4095”.

To test output pins load resistor should be connected between output pin and +24V. Oscilloscope diagrams for PWM are shown below - PWM = 20

PWM= 500

PWM=1000

PWM=2000

PWM=3000

PWM=3980

mycnc/open_collector_outputs_and_pwm_outputs_schematic_design.txt · Last modified: 2017/07/17 13:16 by skirillov

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki