mycnc:mycnc_setup_examples
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_setup_examples [2020/05/14 11:48] – ivan | mycnc:mycnc_setup_examples [2021/03/24 20:52] – skirillov | ||
---|---|---|---|
Line 35: | Line 35: | ||
Max Speed is set in units/ | Max Speed is set in units/ | ||
+ | |||
+ | * //NOTE: Overspeed acts in a manner | ||
7. Set the Backlash in units (mm/inch) for each axis. Backlash is the value that allows for some unexpected play in the machine due to clearance or looseness of mechanical parts. When the controller sends a movement command to the motor, the motor may turn briefly before any actual axis movement begins. That turn is defined as backlash, and can be accounted for in this setting. | 7. Set the Backlash in units (mm/inch) for each axis. Backlash is the value that allows for some unexpected play in the machine due to clearance or looseness of mechanical parts. When the controller sends a movement command to the motor, the motor may turn briefly before any actual axis movement begins. That turn is defined as backlash, and can be accounted for in this setting. | ||
Line 57: | Line 59: | ||
=== How to set up a Lathe/ | === How to set up a Lathe/ | ||
+ | |||
+ | [[quickstart: | ||
+ | |||
1. Select Basic profile as " | 1. Select Basic profile as " | ||
Line 393: | Line 398: | ||
+ | === Setting up a 2-motor X+Y X-Y 3D-printer=== | ||
+ | |||
+ | A 3D printer shown below is an example of a setup which utilized the X+Y and X-Y axis configuration in Settings -> Config -> Axes/ | ||
+ | |||
+ | http:// | ||
+ | http:// | ||
mycnc/mycnc_setup_examples.txt · Last modified: 2024/01/30 12:09 by ivan