mycnc:mycnc_pulse_width_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
mycnc:mycnc_pulse_width_setup [2020/11/26 15:17] – ivan | mycnc:mycnc_pulse_width_setup [2024/01/22 11:05] (current) – ivan | ||
---|---|---|---|
Line 65: | Line 65: | ||
{{: | {{: | ||
*The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | ||
+ | *The pulse width setup is now complete | ||
| | ||
- | * for ЕТ6, ЕТ7 controllers - value 1 is for the first 4 motor outputs, value 2 is for the next 2 motor outputs | + | * for ЕТ6, ЕТ7 controllers |
- | * for ЕТ10 - all channels are equal (use only value 1, values 2 and 3 are not used) | + | * For ET9 controllers (modern ET7 revisions) - **value 1** is for the first 4 motor outputs, **value 2** is for the 5th motor output, **value 3** is for the 6th motor output. Read more about the ET9 [[mycnc: |
- | * for ЕТ15 - value 1 is for the first 4 motor outputs, value 2 is for the next 2 motor outputs, value 3 is for the last 2 motor outputs | + | * for ЕТ10 |
- | {{: | + | * For ET12 controllers (modern ET10 revisions) - **value 1** is for the first 4 motor outputs, **value 2** is for the 5th motor output, **value 3** is for the 6th motor output. |
+ | * for ЕТ15 - **value 1** is for the first 4 motor outputs, | ||
- | | + | |
+ | {{:mycnc:pulse-width: |
mycnc/mycnc_pulse_width_setup.txt · Last modified: 2024/01/22 11:05 by ivan