Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et6 [2019/06/11 11:20] – ivan
+++ mycnc:mycnc_et6 [2019/06/11 11:25] – ivan
@@ Line 62: / Line 62: @@
 ==== Galvanic isolated inputs ====
-ET6 control board has 8 galvanic isolated binary inputs, 2 groups of 4 inputs each. Each group has separate power supply pins so inputs can be powered from different power sources. Using PNP and NPN sensors simultaneously if possible too.
+ET6 control board has 8 galvanic isolated binary inputs, 2 groups of 4 inputs each. Each group has two separate power supply pins so inputs can be powered from different power sources for the convenience of the user. Using PNP and NPN sensors simultaneously is possible too.
 Schematic for ET6 inputs is shown below
@@ Line 77: / Line 77: @@
-RS485 bus schematic is shown below
+RS485 bus schematic is shown below:
 {{hardware:et6:et6-rs485.png}}
-RS485 connector pinout shown below
+RS485 connector pinout shown below:
 {{hardware:et6:et6-rs485-connection-001.jpg}}
@@ Line 90: / Line 90: @@
 Actual Max DAC voltage (ie 10V, 5V, 6V) can be setup in the myCNC control software.
-Schematic design of DAC output is schwn below
+Schematic design of DAC output is shown below:
 {{hardware:et7:et7-dac-output.png}}
-Connector pinout for DAC output
+Connector pinout for DAC output:
 {{hardware:et6:et6-dac-connection-001.jpg}}