mycnc:mycnc_et10
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:mycnc_et10 [2019/10/22 13:27] – ivan | mycnc:mycnc_et10 [2020/01/10 10:05] – ivan | ||
---|---|---|---|
Line 157: | Line 157: | ||
+ | ==== ET10 Single-Board Computer connection ==== | ||
+ | |||
+ | The single board computer (such as a TinkerBoard) should be connected to the myCNC-ET10 controller board in a way shown in the photo below: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Note that the connection MUST be done to the 5V/GND ports of the XT30 connector block and not to the 24V ports of the XT29 block which is located right next to it. Incorrect connection of the power supply may cause damage to the computer. | ||
==== Board dimension ==== | ==== Board dimension ==== |
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan