mycnc:mycnc_et10
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et10 [2019/06/27 14:01] – ivan | mycnc:mycnc_et10 [2019/09/23 09:24] – ivan | ||
---|---|---|---|
Line 171: | Line 171: | ||
==== ET10 Firmware Reflash ==== | ==== ET10 Firmware Reflash ==== | ||
+ | |||
+ | |||
To reflash the board | To reflash the board | ||
- | 1. Unplug 24V DC power supply and detach ET10 controller from Breakout board | + | {{: |
+ | |||
+ | 1. Unplug | ||
2. Plug 24V DC supply | 2. Plug 24V DC supply | ||
Line 179: | Line 183: | ||
3. Short power cable between ET1 and Breakout leave connected. | 3. Short power cable between ET1 and Breakout leave connected. | ||
- | 4. Plugin | + | 4. Plug in the mini-USB cable to ET10 & Host Computer with myCNC installed |
- | 5. Close jumpers J4(reset) & J5)programming) on myCNC controller board | + | 5. Close jumpers J4(reset) & J5 (programming) on the myCNC controller board |
- | 6. Open(remove) J4(reset) jumper. | + | 6. Open (remove) |
- | 7. Open myCNC software on Host computer, then go to Settings > Support Tab | + | 7. Open myCNC software on the Host computer, then go to Settings > Support Tab |
8. " | 8. " | ||
Line 193: | Line 197: | ||
10. "UART port" select port with FT232 attached | 10. "UART port" select port with FT232 attached | ||
- | 11. Baud Rate set to " | + | 11. Baud Rate set to " |
- | 12. Press " | + | 12. Press " |
- | 13. Sector 0 will be written at the end of process, so message in debug window " | + | 13. Sector 0 will be written at the end of process, so message in debug window " |
- | successfully. | + | |
14. Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board. | 14. Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board. | ||
- | If reflashing process failed, please repeat | + | If the reflashing process |
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan