mycnc:mycnc_et10
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:mycnc_et10 [2019/06/27 14:01] – ivan | mycnc:mycnc_et10 [2019/06/28 14:03] – ivan | ||
---|---|---|---|
Line 171: | Line 171: | ||
==== ET10 Firmware Reflash ==== | ==== ET10 Firmware Reflash ==== | ||
+ | |||
+ | |||
To reflash the board | To reflash the board | ||
- | 1. Unplug 24V DC power supply and detach ET10 controller from Breakout board | + | {{: |
+ | |||
+ | 1. Unplug | ||
2. Plug 24V DC supply | 2. Plug 24V DC supply | ||
Line 179: | Line 183: | ||
3. Short power cable between ET1 and Breakout leave connected. | 3. Short power cable between ET1 and Breakout leave connected. | ||
- | 4. Plugin | + | 4. Plug in the mini-USB cable to ET10 & Host Computer with myCNC installed |
5. Close jumpers J4(reset) & J5)programming) on myCNC controller board | 5. Close jumpers J4(reset) & J5)programming) on myCNC controller board |
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan