mycnc:mycnc_et10
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et10 [2019/04/29 11:49] – ivan | mycnc:mycnc_et10 [2019/06/14 12:52] – ivan | ||
---|---|---|---|
Line 63: | Line 63: | ||
=== 3-wire NPN sensor connection example === | === 3-wire NPN sensor connection example === | ||
- | < | + | < |
- | {{:hardware: | + | {{:mycnc:et10-npn-external-001-v2.png}} |
=== 3-wire PNP sensor connection example === | === 3-wire PNP sensor connection example === | ||
- | < | + | < |
- | {{:hardware: | + | {{:mycnc:et10-pnp-external-001-v2.png}} |
- | === Switch | + | === 3-wire NPN sensor |
- | * Internal power supply | + | < |
- | * External power supply (#1) < | + | |
- | * External power supply (#2) < | + | |
+ | {{: | ||
+ | === 3-wire PNP sensor connection example (internal power supply)=== | ||
+ | < | ||
+ | {{: | ||
+ | |||
+ | === Switch connection example=== | ||
+ | |||
+ | * Internal power supply < | ||
+ | * External power supply (#1) < | ||
+ | * External power supply (#2) < | ||
==== ET10 Encoder inputs ==== | ==== ET10 Encoder inputs ==== | ||
Line 136: | Line 144: | ||
The picture below shows an example of a potentiometer connected to ADC2 input. | The picture below shows an example of a potentiometer connected to ADC2 input. | ||
+ | {{: | ||
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan