Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_configuration_dialogs [2020/03/27 10:28] – ivan
+++ mycnc:mycnc_configuration_dialogs [2020/05/07 15:11] – ivan
@@ Line 629: / Line 629: @@
 <code>~/DNC/</code>
-<code>~/Desktop/G-codes/<code>
+<code>~/Desktop/G-codes/</code>
   * The ''~'' symbol allows you to not write out the whole /home/USERNAME/DNC line, however the full filepath can also be used.
@@ Line 1327: / Line 1327: @@
   * Autorepeat generates the rising edge continuously. This behaviour is useful when the button long-press needs to correspond to a gradual increase/decrease in some value, allowing to input some changes over time by continuously transmitting a rising edge signal.
   * Slots describe the available events, which are the same as in the [[mycnc:wireless_pendants|Wireless Pendants]] manual, ranging from job stop/start for quick controls, to jog commands, to running a particular PLC procedure. Please consult the Wireless Pendants list to find out more about the particular Slots and Parameters.
+A tutorial video on setting up a set of hardkeys for machine jog (movement) is available here:
+{{youtube>AXY7eF2yvKY?large}}
 ++++