Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_configuration_dialogs [2020/02/27 11:34] – ivan
+++ mycnc:mycnc_configuration_dialogs [2020/03/12 14:43] – ivan
@@ Line 520: / Line 520: @@
 The following settings are available for macro generation:
-  * **Sensor width**. The sensor width/height is specified here, using a negative value. For example, if the sensor width/height is 1 mm, then the value will be equal to -1.
+  * **Sensor width**. The sensor width/height is specified here.
   * **Sensor number** - specifies the sensor used for the surface measure procedure.
   * **Sensor type** - normally closed or normally open. Check the default behaviour in the Diagnostics window. The default behaviour can be inverted in Hardware > Common Hardware Settings.
@@ Line 1260: / Line 1260: @@
   * The Serial Communication section outlines the connection information and allows the user to load some default sets of keys. Keys can also be imported from a file which is located in the
-  * Keys can be set to trigger a certain action both when pressed and released. It is possible, for example, to set up a key which would pause the program when pressed, and then start it up again when the key is released.
+  * Keys can be set to trigger a certain action both when pressed and released. It is possible, for example, to set up a key which would pause the program when pressed, and then start it up again when the key is released (list of actions [[mycnc:wireless_pendants#assignable_actions|available here]]).
 ++++