Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_configuration_dialogs [2020/01/28 10:07] – ivan
+++ mycnc:mycnc_configuration_dialogs [2020/02/14 13:47] – ivan
@@ Line 48: / Line 48: @@
   * Input type **Normally opened** or **Normally closed** can be selected to the alarm to specify its default behaviour while not triggered. The default behaviour can be checked in the Diagnostics panel and can be inverted in Settings > Config > Hardware > Common Hardware Settings.
-MyCNC software has different **Handlers** for Alarm.
+MyCNC software has different **Handlers** for each Alarm.
+The following alarms are available:
+  * Emergency Button
+  * Collision sensor
+    * //Please note that although although the functions might seem to overlap for some use cases, the collision sensor is set up as a different item in the myCNC settings from the probe sensor. The probe sensor should be set in Probing Wizard > Probing Config.//
+  * X: Servo Driver Ready
+  * X2: Servo Driver Ready
+  * Y: Servo Driver Ready
+  * Z: Servo Driver Ready
+  * A: Servo Driver Ready
+  * B: Servo Driver Ready
+  * C: Servo Driver Ready
+  * Air Pressure
+  * Gas Pressure
+  * Oxygen Pressure
+  * Coolant
+  * Safety Switch
+  * Motor Short Circuit
+  * Spindle Driver Ready
+  * Servo driver(s) alarm
 ++++