mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_configuration_dialogs [2020/01/28 10:07] – ivan | mycnc:mycnc_configuration_dialogs [2020/02/14 13:45] – ivan | ||
|---|---|---|---|
| Line 48: | Line 48: | ||
| * Input type **Normally opened** or **Normally closed** can be selected to the alarm to specify its default behaviour while not triggered. The default behaviour can be checked in the Diagnostics panel and can be inverted in Settings > Config > Hardware > Common Hardware Settings. | * Input type **Normally opened** or **Normally closed** can be selected to the alarm to specify its default behaviour while not triggered. The default behaviour can be checked in the Diagnostics panel and can be inverted in Settings > Config > Hardware > Common Hardware Settings. | ||
| - | MyCNC software has different **Handlers** for Alarm. | + | MyCNC software has different **Handlers** for each Alarm. |
| + | |||
| + | The following alarms are available: | ||
| + | |||
| + | * Emergency Button | ||
| + | * Collision sensor | ||
| + | * //Please note that the collision sensor is set up as a different item in the myCNC settings, the probe sensor should be set in Probing Wizard > Probing Config// | ||
| + | * X: Servo Driver Ready | ||
| + | * X2: Servo Driver Ready | ||
| + | * Y: Servo Driver Ready | ||
| + | * Z: Servo Driver Ready | ||
| + | * A: Servo Driver Ready | ||
| + | * B: Servo Driver Ready | ||
| + | * C: Servo Driver Ready | ||
| + | * Air Pressure | ||
| + | * Gas Pressure | ||
| + | * Oxygen Pressure | ||
| + | * Coolant | ||
| + | * Safety Switch | ||
| + | * Motor Short Circuit | ||
| + | * Spindle Driver Ready | ||
| + | * Servo driver(s) alarm | ||
| ++++ | ++++ | ||
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan