Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_configuration_dialogs [2020/02/19 14:03] – ivan
+++ mycnc:mycnc_configuration_dialogs [2020/03/12 14:43] – ivan
@@ Line 520: / Line 520: @@
 The following settings are available for macro generation:
-  * **Sensor width**. The sensor width/height is specified here, using a negative value. For example, if the sensor width/height is 1 mm, then the value will be equal to -1.
+  * **Sensor width**. The sensor width/height is specified here.
   * **Sensor number** - specifies the sensor used for the surface measure procedure.
   * **Sensor type** - normally closed or normally open. Check the default behaviour in the Diagnostics window. The default behaviour can be inverted in Hardware > Common Hardware Settings.
@@ Line 861: / Line 861: @@
   * Process current (amps) which specifies the current for the machine
   * Kerf compensation method. Kerf compensation can either be done using a standard mill technique for tool radius compensation, or through a dedicated kerf compensation method made specifically for plasma cutting machines. The dedicated plasma method is on by default, and is labelled as Method 1, while the traditional mill machine method is labelled as Method 2. Below is the comparison of the two compensation methods:
-{{:mycnc:config-057-kerf-3.png}}
+{{:mycnc:config-078-kerf-4.png}}
+  * Note how the two methods are different: Method 1 (plasma kerf compensation) will first move out and then begin the cut, then complete the cut while still using kerf compensation, and will then move back to the original starting point. In contrast, the mill Method 2 will begin and end the cut at the same point, gradually moving outwards to reach the tool width compensation value.
   * Auto Gas Console settings. myCNC software allows for gas control using the software PLC commands rather than through the machine. This setting is tailored to the specific customer. If you are interested in the Auto Gas Console settings tailored for your specific needs, please contact the myCNC team through the [[https://www.pv-automation.com/contacts|Contact Us page]].
@@ Line 1257: / Line 1260: @@
   * The Serial Communication section outlines the connection information and allows the user to load some default sets of keys. Keys can also be imported from a file which is located in the
-  * Keys can be set to trigger a certain action both when pressed and released. It is possible, for example, to set up a key which would pause the program when pressed, and then start it up again when the key is released.
+  * Keys can be set to trigger a certain action both when pressed and released. It is possible, for example, to set up a key which would pause the program when pressed, and then start it up again when the key is released (list of actions [[mycnc:wireless_pendants#assignable_actions|available here]]).
 ++++