mycnc:mycnc_configuration_dialogs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_configuration_dialogs [2020/02/19 14:03] – ivan | mycnc:mycnc_configuration_dialogs [2020/03/03 13:55] – ivan | ||
---|---|---|---|
Line 520: | Line 520: | ||
The following settings are available for macro generation: | The following settings are available for macro generation: | ||
- | * **Sensor width**. The sensor width/ | + | * **Sensor width**. The sensor width/ |
* **Sensor number** - specifies the sensor used for the surface measure procedure. | * **Sensor number** - specifies the sensor used for the surface measure procedure. | ||
* **Sensor type** - normally closed or normally open. Check the default behaviour in the Diagnostics window. The default behaviour can be inverted in Hardware > Common Hardware Settings. | * **Sensor type** - normally closed or normally open. Check the default behaviour in the Diagnostics window. The default behaviour can be inverted in Hardware > Common Hardware Settings. | ||
Line 861: | Line 861: | ||
* Process current (amps) which specifies the current for the machine | * Process current (amps) which specifies the current for the machine | ||
* Kerf compensation method. Kerf compensation can either be done using a standard mill technique for tool radius compensation, | * Kerf compensation method. Kerf compensation can either be done using a standard mill technique for tool radius compensation, | ||
- | {{: | + | |
+ | {{: | ||
+ | |||
+ | * Note how the two methods are different: Method 1 (plasma kerf compensation) will first move out and then begin the cut, then complete the cut while still using kerf compensation, | ||
* Auto Gas Console settings. myCNC software allows for gas control using the software PLC commands rather than through the machine. This setting is tailored to the specific customer. If you are interested in the Auto Gas Console settings tailored for your specific needs, please contact the myCNC team through the [[https:// | * Auto Gas Console settings. myCNC software allows for gas control using the software PLC commands rather than through the machine. This setting is tailored to the specific customer. If you are interested in the Auto Gas Console settings tailored for your specific needs, please contact the myCNC team through the [[https:// |
mycnc/mycnc_configuration_dialogs.txt · Last modified: 2022/10/28 15:51 by ivan