mycnc:mql
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mql [2020/02/20 13:43] – ivan | mycnc:mql [2020/10/08 11:15] – ivan | ||
---|---|---|---|
Line 12: | Line 12: | ||
The fine-tuning is done through the built-in PLC procedures, with the setup described in detail in the [[mycnc: | The fine-tuning is done through the built-in PLC procedures, with the setup described in detail in the [[mycnc: | ||
+ | |||
+ | In certain profiles (such as the X1366M4E), the MQL functionality is accessible via the main myCNC screen: | ||
+ | |||
+ | {{: | ||
Line 18: | Line 22: | ||
< | < | ||
- | === Pulse Generator settings in the Software PLC === | + | === Software PLC for MQL === |
The rate, ratio and acceleration can be set up in the Software PLC, as well as in the User Settings widget (the Step-Dir Coolant Control section). | The rate, ratio and acceleration can be set up in the Software PLC, as well as in the User Settings widget (the Step-Dir Coolant Control section). | ||
Line 38: | Line 42: | ||
++++ | ++++ | ||
- | === Pulse Generator settings in Hardware PLC === | + | === Hardware PLC for MQL === |
+ | |||
+ | In addition to the software HANDLER_INIT PLC, certain hardware PLC procedures must be changed for the Minimum Quantity Lubrication to be set up. | ||
Function '' | Function '' |
mycnc/mql.txt · Last modified: 2020/10/08 11:37 by ivan