mycnc:mpg_through_binary_inputs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
mycnc:mpg_through_binary_inputs [2019/11/15 09:40] – ivan | mycnc:mpg_through_binary_inputs [2019/11/15 09:57] – ivan | ||
---|---|---|---|
Line 42: | Line 42: | ||
If you use the [[https:// | If you use the [[https:// | ||
- | | + | |
- | * After activation, you can select the encoder number on the controller for to specify which encoder will be operated | + | {{ : |
- | * It is also necessary to select the MPG function (MPG wheel/ | + | |
+ | | ||
+ | * After activation, you can select the encoder number on the controller for to specify which encoder will be operated | ||
+ | * It is also necessary to select the MPG function (MPG wheel/ | ||
^Functions^Discriptions^ | ^Functions^Discriptions^ | ||
Line 52: | Line 55: | ||
* If necessary, select the coordinate axis which will be controlled by MPG. This will allow to move the machine along that axis when the MPG wheel is turned. | * If necessary, select the coordinate axis which will be controlled by MPG. This will allow to move the machine along that axis when the MPG wheel is turned. | ||
- | {{ : | ||
* Next we select the length of displacements with the help of MPG. This specifies the length of each movement per one click of the MPG wheel (turning by one mark). //Note that this number is IGNORED when using the '' | * Next we select the length of displacements with the help of MPG. This specifies the length of each movement per one click of the MPG wheel (turning by one mark). //Note that this number is IGNORED when using the '' | ||
- | {{ : | + | |
- | | + | |
{{: | {{: | ||
- | * The encoder resolution is hard-coded to be 65536. | + | * The encoder resolution is hard-coded to be 65536 (as of November 2019). |
The diagram below shows an example of an MPG wheel connection to the ET10 controller (in this example, the MPG wheel in connected to the encoder input #5): | The diagram below shows an example of an MPG wheel connection to the ET10 controller (in this example, the MPG wheel in connected to the encoder input #5): |
mycnc/mpg_through_binary_inputs.txt · Last modified: 2019/12/30 11:41 by ivan