mycnc:mpg_through_binary_inputs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
mycnc:mpg_through_binary_inputs [2019/11/14 12:51] – ivan | mycnc:mpg_through_binary_inputs [2019/11/15 09:57] – ivan | ||
---|---|---|---|
Line 42: | Line 42: | ||
If you use the [[https:// | If you use the [[https:// | ||
- | | + | |
- | * After activation, you can select the encoder number on the controller for to specify which encoder will be operated | + | {{ : |
- | * It is also necessary to select the MPG function (MPG wheel/ | + | |
+ | | ||
+ | * After activation, you can select the encoder number on the controller for to specify which encoder will be operated | ||
+ | * It is also necessary to select the MPG function (MPG wheel/ | ||
^Functions^Discriptions^ | ^Functions^Discriptions^ | ||
Line 52: | Line 55: | ||
* If necessary, select the coordinate axis which will be controlled by MPG. This will allow to move the machine along that axis when the MPG wheel is turned. | * If necessary, select the coordinate axis which will be controlled by MPG. This will allow to move the machine along that axis when the MPG wheel is turned. | ||
- | {{ : | ||
* Next we select the length of displacements with the help of MPG. This specifies the length of each movement per one click of the MPG wheel (turning by one mark). //Note that this number is IGNORED when using the '' | * Next we select the length of displacements with the help of MPG. This specifies the length of each movement per one click of the MPG wheel (turning by one mark). //Note that this number is IGNORED when using the '' | ||
- | {{ : | + | |
- | | + | |
{{: | {{: | ||
- | * The encoder resolution is hard-coded to be 65536. | + | * The encoder resolution is hard-coded to be 65536 (as of November 2019). |
- | The following | + | The diagram |
{{: | {{: | ||
- | As already mentioned, axis control can be set up directly from the //MPG through binary inputs// settings window. In order to set up this encoder to change some values within the software (such as jog overspeed, motion overspeed, etc), the user can go into Settings > Config > Inputs/ | + | As already mentioned, axis jog control can be set up directly from the //MPG through binary inputs// settings window. In order to set up this encoder to change some values within the software (such as jog overspeed, motion overspeed, etc), the user can go into Settings > Config > Inputs/ |
* In the **Source** field, select Encoder. | * In the **Source** field, select Encoder. | ||
* For the **parameter**, | * For the **parameter**, | ||
Line 73: | Line 74: | ||
{{: | {{: | ||
- | This will allow us to use the MPG wheel connected to the encoder inputs to change a number of myCNC parameters of the fly. | + | This will allow the operator |
mycnc/mpg_through_binary_inputs.txt · Last modified: 2019/12/30 11:41 by ivan