mycnc:mpg_through_binary_inputs
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mpg_through_binary_inputs [2019/11/14 12:51] – ivan | mycnc:mpg_through_binary_inputs [2019/11/14 12:51] – ivan | ||
|---|---|---|---|
| Line 58: | Line 58: | ||
| {{: | {{: | ||
| * The encoder resolution is hard-coded to be 65536. | * The encoder resolution is hard-coded to be 65536. | ||
| - | |||
| - | * This is different from encoder setup in the Settings > Config > Hardware > Encoders section. In here, it is the number of lines/ | ||
| - | {{: | ||
| The following diagram shows an example of an MPG wheel connection to the ET10 controller (in this example, the MPG wheel in connected to the encoder input #5): | The following diagram shows an example of an MPG wheel connection to the ET10 controller (in this example, the MPG wheel in connected to the encoder input #5): | ||
mycnc/mpg_through_binary_inputs.txt · Last modified: 2019/12/30 11:41 by ivan