Differences

This shows you the differences between two versions of the page.

--- mycnc:flatbed_correction [2020/02/18 15:27] – ivan
+++ mycnc:flatbed_correction [2020/02/24 09:30] – ivan
@@ Line 1: / Line 1: @@
 =====myCNC Flatbed Correction=====
-This article discusses the flatbed correction feature built into myCNC software which is often useful when the working table is not even or has certain spots which are higher or lower than the reference position. This is especially useful in cases when something like a tangential knife needs to go over the uneven table, with up to a millimeter of play being involved, resulting in a cut that does not actually go through the working material properly.
+This article discusses the flatbed correction feature built into myCNC software which is often useful when the working table is not even or has certain spots which are higher or lower than the reference position. This is especially useful in cases when something like a tangential knife needs to go over the uneven table, resulting in a cut that does not actually go through the working material properly, or alternatively a cut that goes far too deep into the material.
 In order to account for this, flatbed correction is used.