mycnc:flatbed_correction
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:flatbed_correction [2020/02/18 15:23] – ivan | mycnc:flatbed_correction [2020/02/24 09:30] – ivan | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| =====myCNC Flatbed Correction===== | =====myCNC Flatbed Correction===== | ||
| - | This article discusses the flatbed correction feature built into myCNC software which is often useful when the working table is not even or has certain spots which are higher or lower than the reference position. This is especially useful in cases when something like a tangential knife needs to go over the uneven table, with up to a millimeter of play being involved, resulting in a cut that does not actually go through the working material properly. | + | This article discusses the flatbed correction feature built into myCNC software which is often useful when the working table is not even or has certain spots which are higher or lower than the reference position. This is especially useful in cases when something like a tangential knife needs to go over the uneven table, resulting in a cut that does not actually go through the working material properly, or alternatively a cut that goes far too deep into the material. |
| In order to account for this, flatbed correction is used. | In order to account for this, flatbed correction is used. | ||
| Line 23: | Line 23: | ||
| The **Auto Measure Procedure** button can be pressed to begin the probing process. | The **Auto Measure Procedure** button can be pressed to begin the probing process. | ||
| - | {{: | + | {{: |
| //NOTE: If you leave the flatbed correction setting screen while the procedure is running, the measurement program will be paused until you return back to the screen.// | //NOTE: If you leave the flatbed correction setting screen while the procedure is running, the measurement program will be paused until you return back to the screen.// | ||
mycnc/flatbed_correction.txt · Last modified: 2022/12/01 11:37 by ivan