mycnc:flatbed_correction
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:flatbed_correction [2020/02/14 14:29] – ivan | mycnc:flatbed_correction [2020/02/18 15:27] – ivan | ||
---|---|---|---|
Line 3: | Line 3: | ||
This article discusses the flatbed correction feature built into myCNC software which is often useful when the working table is not even or has certain spots which are higher or lower than the reference position. This is especially useful in cases when something like a tangential knife needs to go over the uneven table, with up to a millimeter of play being involved, resulting in a cut that does not actually go through the working material properly. | This article discusses the flatbed correction feature built into myCNC software which is often useful when the working table is not even or has certain spots which are higher or lower than the reference position. This is especially useful in cases when something like a tangential knife needs to go over the uneven table, with up to a millimeter of play being involved, resulting in a cut that does not actually go through the working material properly. | ||
+ | In order to account for this, flatbed correction is used. | ||
- | In order to account for this, go into **Settings > Config > Technology > Special Purpose > Flatbed Correction**. | + | The following video goes over the basic process of setting up flatbed correction within myCNC software: |
+ | |||
+ | {{youtube> | ||
+ | |||
+ | To set up flatbed correction, into **Settings > Config > Technology > Special Purpose > Flatbed Correction**. | ||
The screen presented to you will be the following: | The screen presented to you will be the following: | ||
- | {{: | + | {{: |
+ | |||
+ | After the setup process has been completed, a table of points in the XY-plane and their Z-positions will be presented on this page. These values can either be recorded by using the AutoMeasure procedure, or by using a sensor and recording each point individually by using the M402 macro. | ||
+ | |||
+ | Using the AutoMeasure procedure, the operator can set the measurement distances for the X and Y axes as well as the number of points at which the height measurements will be taken for the XY-plane. | ||
+ | |||
+ | **Note:** Flatbed correction **must be disabled** prior to beginning taking the measurements, | ||
+ | |||
+ | The **Auto Measure Procedure** button can be pressed to begin the probing process. | ||
+ | |||
+ | {{: | ||
- | The table on this settings page presents a number of values in the XY-plane and their z-positions. These values can either be recorded by using the AutoMeasure | + | //NOTE: If you leave the flatbed correction setting screen while the procedure |
- | Using the AutoMeasure | + | After the measurement |
- | {{:mycnc:flatbed-update-007-automeasure.png}} | + | //NOTE: The myCNC flatbed |
- | In order to use the M402 macro, move the sensor to the position you want to measure, then press the **Measure (M402) and Save** button. This will lower the sensor down until contact, then lift it back up and record the z-position at which the sensor was triggered. | + | In order to use the M402 macro for manual point measurement, move the sensor to the position you want to measure, then press the **Measure (M402) and Save** button. This will lower the sensor down until contact, then lift it back up and record the z-position at which the sensor was triggered. |
{{: | {{: | ||
Line 24: | Line 39: | ||
{{: | {{: | ||
- | By adding these correction points, myCNC software will create | + | By adding these correction points, myCNC software will create |
====M402 macro==== | ====M402 macro==== |
mycnc/flatbed_correction.txt · Last modified: 2022/12/01 11:37 by ivan