mycnc:change_ip_address_for_tinkerboard_sbc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:change_ip_address_for_tinkerboard_sbc [2018/03/31 14:14] – skirillov | mycnc:change_ip_address_for_tinkerboard_sbc [2018/03/31 14:18] – skirillov | ||
|---|---|---|---|
| Line 32: | Line 32: | ||
| 3. Edit **Address** to fix LAN IP Address as you need. Press **F2**, **Enter** keys to save changes. Reboot computer. | 3. Edit **Address** to fix LAN IP Address as you need. Press **F2**, **Enter** keys to save changes. Reboot computer. | ||
| + | {{tinker: | ||
| + | | We noticed that only the last address is configured if LAN connectir is dicsconnected while computer boot. \\ Laa IP addresses in **interfaces** configuration file should be setup if LAN connector is connected to Network while boot | | ||
mycnc/change_ip_address_for_tinkerboard_sbc.txt · Last modified: 2018/03/31 14:21 by skirillov