Differences

This shows you the differences between two versions of the page.

--- mycnc:alarms [2018/07/22 10:49] – pupalaiser
+++ mycnc:alarms [2021/10/06 09:51] – ivan
@@ Line 1: / Line 1: @@
 **Alarms**
-This section allows you to specify the alarm inputs and the response to these sensors.
+  * This section allows you to specify the alarm inputs and the response to these sensors.
-{{:mycnc:imput.png|}}
+{{:mycnc:alarms-002-main-window-description.png}}
-The selected sensor is activated by setting the "V" symbol in the corresponding field.
-{{:mycnc:imput3.png|}}
+  * The selected sensor is activated by setting the "V" symbol in the corresponding field.
-The input number on the controller board is set in the corresponding field "Inputs Number"
+{{:mycnc:alarms-003-sensor-name.png}}
-Numbering of inputs can be found in the documentation for the selected window controller.
-{{:mycnc:imput4.png|}}
+  * The input number on the controller board is set in the corresponding field "Inputs Number". Numbering of inputs can be found in the documentation for the selected window controller.
-The type of the sensor is specified in the corresponding field "".
+{{:mycnc:alarms-004-input-number.png}}
-There are two types of input sensors. Normally open - the sensor in the rest position has not closed contacts and in the course of operation the sensor contacts are closed. Normally closed - the sensor in the rest position has closed contacts and during the operation, the sensor contacts are opened.
-{{:mycnc:imput5.png|}}
+  * The type of the sensor is specified in the corresponding field "". There are two types of input sensors. Normally open - the sensor in the rest position has open contacts and in the course of operation the sensor contacts are closed. Normally closed - the sensor in the rest position has closed contacts and during the operation, the sensor contacts are opened.
+{{:mycnc:alarms-005-sensor-type.png}}
+* Additionally, the program can launch a Software PLC command when an alarm is triggered, by specifying a Software PLC handler in this next field:
+{{:mycnc:alarms-006-soft-plc.png}}
+You can read up more on Software PLC programming here: [[plc:plc|PLC]]
 __//Table of alarm sensors//__
@@ Line 31: / Line 37: @@
 |Shpindle Driver Ready|The spindle driver is ready for operation. This sensor is usually installed directly in the spindle drive, but it can also be done on its own.|
 |Servo Driver(s) Alarm|Accident of any of the drives installed on the machine. As a rule, the signal of an accident is directly the drive of the engine.|