faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
faq [2020/02/18 09:16] – ivan | faq [2020/03/02 15:29] – ivan | ||
---|---|---|---|
Line 18: | Line 18: | ||
If you would like more information about all the particular buttons and on-screen elements in a particular myCNC profile, please consult the [[mycnc: | If you would like more information about all the particular buttons and on-screen elements in a particular myCNC profile, please consult the [[mycnc: | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ How to load G-code or DXF files into the software? | | ||
+ | |||
+ | The files that you are attempting to load must be located in folders that are specified in the **Settings > Config > Preferences > Common** fields for **NC code folders**. If a folder that you would like to load your files from is missing, add it on a new line and press the Save Configuration button: | ||
+ | |||
+ | {{:: | ||
+ | |||
+ | If a folder is not listed in the NC code folders list (or is not within one of the folders listed), you will not be able to open files from it within the myCNC application. | ||
+ | |||
+ | After you have listed the folders that you would like to have access to, you can open files using the **Open G-code** and **Open DXF** buttons from the main software screen: | ||
+ | |||
+ | {{:: | ||
++++ | ++++ |
faq.txt · Last modified: 2024/02/20 10:07 by ivan