quickstart:mycnc-quick-start:tangential-knife-setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 13:51] – ivan | quickstart:mycnc-quick-start:tangential-knife-setup [2019/11/04 10:01] – ivan | ||
|---|---|---|---|
| Line 51: | Line 51: | ||
| The DXF import procedure automatically generates the knife turn/knife lift G-codes which are inserted into the program, and which correspond with the settings listed in Config > Technology > Tangential Knife. This allows for easy set up provided the DXF file has been correctly modelled. | The DXF import procedure automatically generates the knife turn/knife lift G-codes which are inserted into the program, and which correspond with the settings listed in Config > Technology > Tangential Knife. This allows for easy set up provided the DXF file has been correctly modelled. | ||
| + | |||
| + | A full manual on importing DXF files is available [[quickstart: | ||
quickstart/mycnc-quick-start/tangential-knife-setup.txt · Last modified: 2020/09/14 09:11 by ivan