quickstart:mycnc-quick-start:tangential-knife-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 13:35] – ivan | quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 13:51] – ivan | ||
---|---|---|---|
Line 41: | Line 41: | ||
*Select your tool in the top section (Knife in this particular configuration, | *Select your tool in the top section (Knife in this particular configuration, | ||
*Select your Tool Lift. This height will specify how high the knife will be lifted as it travels between parts. | *Select your Tool Lift. This height will specify how high the knife will be lifted as it travels between parts. | ||
+ | * | ||
*Select your Working Height (usually left at 0) | *Select your Working Height (usually left at 0) | ||
*Insert any necessary commands into the Header/ | *Insert any necessary commands into the Header/ |
quickstart/mycnc-quick-start/tangential-knife-setup.txt · Last modified: 2020/09/14 09:11 by ivan