Differences

This shows you the differences between two versions of the page.

--- quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 11:32] – ivan
+++ quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 11:37] – ivan
@@ Line 45: / Line 45: @@
   *Choose your X-Y offset
   *If using multiple tools, such as a knife/creasing wheel combo, set up the priorities for the tools which correspond to the DXF file layers (so as to assign a correct tool to each layer). Press Save.
+  *Press the check mark in the bottom right section of the screen to load the DXF file into myCNC. The file should now be loaded and displayed on your main screen:
-  *
+{{:quickstart:mycnc-quick-start:tangential-dxf-002.png}}