Differences

This shows you the differences between two versions of the page.

--- quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 11:17] – ivan
+++ quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 11:32] – ivan
@@ Line 38: / Line 38: @@
 {{:quickstart:mycnc-quick-start:tangential-dxf-001.png}}
+  *Select your tool in the top section (Knife in this particular configuration, Half-Knife, Creasing Wheel and Camera can also be used).
+  *Select your Tool Lift. This height will specify how high the knife will be lifted as it travels between parts.
+  *Select your Working Height (usually left at 0)
+  *Insert any necessary commands into the Header/Footer fields. These are usually left blank, unless it is necessary to add some particular command to the G-code generated from the DXF file after the Tool Change. \
+  *Choose your X-Y offset
+  *If using multiple tools, such as a knife/creasing wheel combo, set up the priorities for the tools which correspond to the DXF file layers (so as to assign a correct tool to each layer). Press Save.
   *