quickstart:mycnc-quick-start:tangential-knife-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 11:17] – ivan | quickstart:mycnc-quick-start:tangential-knife-setup [2019/07/02 11:37] – ivan | ||
---|---|---|---|
Line 39: | Line 39: | ||
{{: | {{: | ||
- | * | + | *Select your tool in the top section (Knife in this particular configuration, |
+ | *Select your Tool Lift. This height will specify how high the knife will be lifted as it travels between parts. | ||
+ | *Select your Working Height (usually left at 0) | ||
+ | *Insert any necessary commands into the Header/ | ||
+ | *Choose your X-Y offset | ||
+ | *If using multiple tools, such as a knife/ | ||
+ | *Press the check mark in the bottom right section of the screen to load the DXF file into myCNC. The file should now be loaded and displayed on your main screen: | ||
+ | |||
+ | {{: | ||
quickstart/mycnc-quick-start/tangential-knife-setup.txt · Last modified: 2020/09/14 09:11 by ivan