quickstart:mycnc-quick-start:probe_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:probe_setup [2020/02/10 13:17] – ivan | quickstart:mycnc-quick-start:probe_setup [2020/02/14 13:39] – ivan | ||
---|---|---|---|
Line 37: | Line 37: | ||
{{: | {{: | ||
- | ====Probing Wizard Setup in Mill profile==== | + | ====Probing Wizard Setup==== |
- | In order to properly set up a probe system | + | In order to properly set up a probe system from scratch on your machine (especially if the software has not, for any reason, been updated to its latest version) please check the following: |
1. In **CNC Settings > PLC > Hardware PLC**, check that the command **TRIG04** is created. The program should contain the following code: | 1. In **CNC Settings > PLC > Hardware PLC**, check that the command **TRIG04** is created. The program should contain the following code: | ||
Line 72: | Line 73: | ||
The probe wizard setup should now be complete. | The probe wizard setup should now be complete. | ||
+ | //NOTE: Please not that probing configuration is separate from setting up items such as collision sensors, emergency stop buttons, etc, due to the use of different macros / PLC procedures. // | ||
====Using the probe sensor in myCNC software==== | ====Using the probe sensor in myCNC software==== |
quickstart/mycnc-quick-start/probe_setup.txt · Last modified: 2021/08/04 14:18 by ivan