quickstart:mycnc-quick-start:probe_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:probe_setup [2019/07/04 09:34] – ivan | quickstart:mycnc-quick-start:probe_setup [2019/07/04 10:13] – ivan | ||
---|---|---|---|
Line 7: | Line 7: | ||
In order to properly adjust the probe before starting the measurement procedure, it is necessary to eliminate any deviation that might be otherwise present in the probe. For this purpose, an indicator is used, as shown in the image below. This indicator should be sensitive to small forces of about 0.3-0.5 Newtons. | In order to properly adjust the probe before starting the measurement procedure, it is necessary to eliminate any deviation that might be otherwise present in the probe. For this purpose, an indicator is used, as shown in the image below. This indicator should be sensitive to small forces of about 0.3-0.5 Newtons. | ||
- | {{: | + | {{: |
The spindle axis is moved by hand, and the amplitude of the sensor deviation is recorded using the indicator. | The spindle axis is moved by hand, and the amplitude of the sensor deviation is recorded using the indicator. | ||
Line 13: | Line 13: | ||
The deviation is eliminated by turning the M2.5 adjustment screws with the 2mm hex key included in the probe kit: | The deviation is eliminated by turning the M2.5 adjustment screws with the 2mm hex key included in the probe kit: | ||
- | {{: | + | {{: |
It is recommended to hold the key by a short lever, as to prevent excessive force application. It might be necessary to perform several cycles of spindle calibration to adjust the probe to have the minimum acceptable deviation. | It is recommended to hold the key by a short lever, as to prevent excessive force application. It might be necessary to perform several cycles of spindle calibration to adjust the probe to have the minimum acceptable deviation. | ||
- | {{: | + | |
+ | {{: | ||
quickstart/mycnc-quick-start/probe_setup.txt · Last modified: 2021/08/04 14:18 by ivan