quickstart:mycnc-quick-start:oxyfuel-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 12:24] – ivan | quickstart:mycnc-quick-start:oxyfuel-setup [2021/08/09 14:21] (current) – ivan | ||
---|---|---|---|
Line 2: | Line 2: | ||
This article introduces the reader to the basics of oxy-fuel (gas) cutting setup using myCNC software. | This article introduces the reader to the basics of oxy-fuel (gas) cutting setup using myCNC software. | ||
+ | |||
+ | The profile screen description for the oxy-fuel cutting profiles (X1366G/ | ||
Upon opening the 1366G profile (gas cutting/ | Upon opening the 1366G profile (gas cutting/ | ||
Line 43: | Line 45: | ||
On most machines, THC and IHC are usually not required for the operator, so these should be turned off by default: | On most machines, THC and IHC are usually not required for the operator, so these should be turned off by default: | ||
{{: | {{: | ||
+ | |||
+ | ====Start/ | ||
+ | |||
+ | For proper oxyfuel cutting start, it is necessary to set the **Direct Move** option in Start/Stop settings. Failure to do so may result in incorrect behaviour for certain procedures, such as Cutting from Edge: | ||
+ | |||
+ | {{: | ||
====Controller Output Connections==== | ====Controller Output Connections==== |
quickstart/mycnc-quick-start/oxyfuel-setup.1561134275.txt.gz · Last modified: 2019/06/21 12:24 by ivan