Differences

This shows you the differences between two versions of the page.

--- quickstart:mycnc-quick-start:oxyfuel-setup [2020/09/14 09:10] – ivan
+++ quickstart:mycnc-quick-start:oxyfuel-setup [2021/08/09 14:21] (current) – ivan
@@ Line 45: / Line 45: @@
 On most machines, THC and IHC are usually not required for the operator, so these should be turned off by default:
 {{:quickstart:mycnc-quick-start:oxyfuel-quickstart-thc-002.png}}
+====Start/Stop Setup====
+For proper oxyfuel cutting start, it is necessary to set the **Direct Move** option in Start/Stop settings. Failure to do so may result in incorrect behaviour for certain procedures, such as Cutting from Edge:
+{{:examples:plasma-oxyfuel-setup-003-direct-move.jpg}}
 ====Controller Output Connections====