quickstart:mycnc-quick-start:oxyfuel-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 12:21] – ivan | quickstart:mycnc-quick-start:oxyfuel-setup [2020/09/14 09:10] – ivan | ||
---|---|---|---|
Line 2: | Line 2: | ||
This article introduces the reader to the basics of oxy-fuel (gas) cutting setup using myCNC software. | This article introduces the reader to the basics of oxy-fuel (gas) cutting setup using myCNC software. | ||
+ | |||
+ | The profile screen description for the oxy-fuel cutting profiles (X1366G/ | ||
Upon opening the 1366G profile (gas cutting/ | Upon opening the 1366G profile (gas cutting/ | ||
Line 62: | Line 64: | ||
{{: | {{: | ||
+ | |||
+ | ==Simpler Controller Connections== | ||
Note that the image above refers to a full configuration for an oxy-fuel cutting machine equipped with all the possible oxygen flows as well as an ignition cycle. A simpler machine connection configuration with only one pressure of cutting and heating oxygen, a fuel supply and no ignition torch will look as follows: | Note that the image above refers to a full configuration for an oxy-fuel cutting machine equipped with all the possible oxygen flows as well as an ignition cycle. A simpler machine connection configuration with only one pressure of cutting and heating oxygen, a fuel supply and no ignition torch will look as follows: |
quickstart/mycnc-quick-start/oxyfuel-setup.txt · Last modified: 2021/08/09 14:21 by ivan