Differences

This shows you the differences between two versions of the page.

--- quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 11:41] – ivan
+++ quickstart:mycnc-quick-start:oxyfuel-setup [2020/09/14 09:10] – ivan
@@ Line 2: / Line 2: @@
 This article introduces the reader to the basics of oxy-fuel (gas) cutting setup using myCNC software.
+The profile screen description for the oxy-fuel cutting profiles (X1366G/X1366GA) is available here: [[mycnc:mycnc_setup_examples:gas_cutting|Basic profile for Gas Cutting.]]
 Upon opening the 1366G profile (gas cutting/welding profile) and navigating to the User Settings, the operator is presented with the following window:
@@ Line 59: / Line 61: @@
 |OUT10|Ignition (spark)|
-Note that every one of these outputs can be reconfigured if the user so desires. However, in this default configuration, connecting the controller to the machine looks as follows:
+Every one of these outputs can be reconfigured if the user so desires. However, in this default configuration, connecting the controller to the machine looks as follows:
 {{:quickstart:mycnc-quick-start:oxyfuel-quickstart-008-et7connection.png}}
+==Simpler Controller Connections==
+Note that the image above refers to a full configuration for an oxy-fuel cutting machine equipped with all the possible oxygen flows as well as an ignition cycle. A simpler machine connection configuration with only one pressure of cutting and heating oxygen, a fuel supply and no ignition torch will look as follows:
+{{:quickstart:mycnc-quick-start:oxyfuel-quickstart-008-et7connection2.png}}