Differences

This shows you the differences between two versions of the page.

--- quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 11:41] – ivan
+++ quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 12:21] – ivan
@@ Line 59: / Line 59: @@
 |OUT10|Ignition (spark)|
-Note that every one of these outputs can be reconfigured if the user so desires. However, in this default configuration, connecting the controller to the machine looks as follows:
+Every one of these outputs can be reconfigured if the user so desires. However, in this default configuration, connecting the controller to the machine looks as follows:
 {{:quickstart:mycnc-quick-start:oxyfuel-quickstart-008-et7connection.png}}
+Note that the image above refers to a full configuration for an oxy-fuel cutting machine equipped with all the possible oxygen flows as well as an ignition cycle. A simpler machine connection configuration with only one pressure of cutting and heating oxygen, a fuel supply and no ignition torch will look as follows:
+{{:quickstart:mycnc-quick-start:oxyfuel-quickstart-008-et7connection2.png}}