quickstart:mycnc-quick-start:oxyfuel-setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 11:38] – ivan | quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 11:41] – ivan | ||
|---|---|---|---|
| Line 46: | Line 46: | ||
| ====Controller Output Connections==== | ====Controller Output Connections==== | ||
| - | In order to check the proper output connections for connecting the controller to the machine setup, go to **Settings > PLC > Hardware PLC > pins.h**. The screen presented to you will be the one below: | + | In order to check the proper output connections for connecting the controller to the machine setup, go to **Settings > PLC > Hardware PLC > pins.h**. The current output configuration can be found on the screen |
| - | {{: | + | {{: |
| As can be seen here, the following outputs are currently assigned: | As can be seen here, the following outputs are currently assigned: | ||
quickstart/mycnc-quick-start/oxyfuel-setup.txt · Last modified: 2021/08/09 14:21 by ivan