Differences

This shows you the differences between two versions of the page.

--- quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 11:34] – created ivan
+++ quickstart:mycnc-quick-start:oxyfuel-setup [2019/06/21 11:41] – ivan
@@ Line 39: / Line 39: @@
 //OC low// is the low-pressure cutting oxygen flow. It is started slightly before the //OC high// (high-pressure cutting oxygen) flow as to prevent the heated metal from splashing onto the torch. Note that if only one cutting oxygen flow is available, //OC low// connection should be used when setting up the machine.
+===THC and IHC===
+On most machines, THC and IHC are usually not required for the operator, so these should be turned off by default:
+{{:quickstart:mycnc-quick-start:oxyfuel-quickstart-thc-002.png}}
 ====Controller Output Connections====
-In order to check the proper output connections for connecting the controller to the machine setup, go to **Settings > PLC > Hardware PLC > pins.h**. The screen presented to you will be the one below:
+In order to check the proper output connections for connecting the controller to the machine setup, go to **Settings > PLC > Hardware PLC > pins.h**. The current output configuration can be found on the screen such as the one presented to you below:
-{{:quickstart:mycnc-quick-start:oxyfuel-quickstart-002.png}}
+{{:quickstart:mycnc-quick-start:oxyfuel-quickstart-009.png}}
 As can be seen here, the following outputs are currently assigned: