quickstart:mycnc-quick-start:homing_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:homing_setup [2019/06/07 13:47] – ivan | quickstart:mycnc-quick-start:homing_setup [2019/06/07 13:55] – ivan | ||
---|---|---|---|
Line 5: | Line 5: | ||
In order to set up the homing procedure, do the following: | In order to set up the homing procedure, do the following: | ||
- | 1. Go to **CNC Settings > Config > Macro List > M138**, and comment out the axes and commands which are not required for your particular setup by adding **;** in front of the commands, as shown in the screenshot below. For the configuration used in this example, the machine uses three axes (x, y and z), so the a-axis is not required. | + | 1. Go to **CNC Settings > Config > Macro List > M138**, and comment out the axes and commands which are not required for your particular setup by adding **;** in front of the commands, as shown in the screenshot below. For the configuration used in this example, the machine uses three axes (x, y and z), so the a-axis is not required, as well as the commands in the first half of the macro. |
{{: | {{: | ||
quickstart/mycnc-quick-start/homing_setup.txt · Last modified: 2022/10/21 13:54 by ivan