quickstart:mycnc-load-nccodes-from-usb
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
quickstart:mycnc-load-nccodes-from-usb [2019/05/29 13:13] – skirillov | quickstart:mycnc-load-nccodes-from-usb [2019/05/29 13:16] (current) – skirillov | ||
---|---|---|---|
Line 12: | Line 12: | ||
press **close** | press **close** | ||
+ | |||
+ | |||
+ | {{ : | ||
+ | |||
After it USB flash drives will be automatically mounted into the system folder **/ | After it USB flash drives will be automatically mounted into the system folder **/ | ||
< | < | ||
Line 25: | Line 29: | ||
</ | </ | ||
- | |||
- | {{ : | ||
Goto **myCNC software** | Goto **myCNC software** | ||
**Config** **Preferences** | **Config** **Preferences** | ||
+ | |||
+ | Add folder name where USB flash drives will be mounted - | ||
+ | |||
+ | **/ | ||
+ | |||
+ | and press **Save** | ||
{{ : | {{ : | ||
- | {{ : | + | Now you should be able to open files directly |
{{ : | {{ : |
quickstart/mycnc-load-nccodes-from-usb.txt · Last modified: 2019/05/29 13:16 by skirillov