plc:plc_examples
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
plc:plc_examples [2020/02/03 15:06] – ivan | plc:plc_examples [2021/01/21 12:31] – ivan | ||
---|---|---|---|
Line 390: | Line 390: | ||
This PLC can be added to the DXF footer in **Settings > Config > DXF Import Settings** to run every time when the program generated from an imported DXF file finishes running. | This PLC can be added to the DXF footer in **Settings > Config > DXF Import Settings** to run every time when the program generated from an imported DXF file finishes running. | ||
+ | NOTE: Since M212 changes the current coordinate value, it is necessary to always have a positioning command of the format '' | ||
+ | |||
+ | If, for example, the coordinate is reset to 0 inside the PLC, then the next code after the PLC must be '' | ||
+ | |||
+ | When analyzing the program, by default the software does not know that the coordinate inside the PLC has changed, and thus the subsequent G0 command must be used to update it (G1/G2/G3 are NOT suitable for this). | ||
+ | |||
+ | However, the G0 code is only necessary if the M212 is embedded into a G-code program. If the M212 PLC is started independently (for example by clicking a the button which launches the M212 alone), then it doesn' | ||
plc/plc_examples.txt · Last modified: 2024/02/21 13:59 by ivan