Differences

This shows you the differences between two versions of the page.

--- plc:plc_examples [2019/09/10 14:00] – ivan
+++ plc:plc_examples [2020/01/30 12:56] – ivan
@@ Line 184: / Line 184: @@
 {{:plc:five-axes-motion-angle-002.png}}
-The M212 macro exists to remove this positive/negative degree turn that is larger than 360 degrees at the program start. This is useful if the user wants to stop the knife from spinning back multiple times to its 0 position on the c-axis as the program is starting (however, this will still allow the knife to rotate an angle less than a full revolution in order to align itself properly).
+The M212 PLC exists to remove this positive/negative degree turn that is larger than 360 degrees at the program start. This is useful if the user wants to stop the knife from spinning back multiple times to its 0 position on the c-axis as the program is starting (however, this will still allow the knife to rotate an angle less than a full revolution in order to align itself properly).
-The macro is provided with the myCNC software, and looks as follows:
+This PLC is provided with the myCNC software, and looks as follows:
 <code>main()
@@ Line 215: / Line 215: @@
 };</code>
-This macro can be added to the DXF footer in **Settings > Config > DXF Import Settings** to run every time when the program generated from an imported DXF file finishes running.
+This PLC can be added to the DXF footer in **Settings > Config > DXF Import Settings** to run every time when the program generated from an imported DXF file finishes running.