mycnc:wireless_pendants
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:wireless_pendants [2020/03/12 14:39] – ivan | mycnc:wireless_pendants [2020/03/12 15:29] – ivan | ||
---|---|---|---|
Line 38: | Line 38: | ||
| Job: Play 1 line | Run through a single command line (next line) | | | Job: Play 1 line | Run through a single command line (next line) | | ||
| Job: Play 1 line backwards | Run through a single command line (previous line) | | | Job: Play 1 line backwards | Run through a single command line (previous line) | | ||
- | | Job: Back to path | Run a predefined G-code command (the command must be written out in the Message slot) | | + | | Job: Run G-code |
- | | Job: Back to path | Run a predefined G-code after confirming via a confirmation window (the G-code command must be written out in the Message slot). | + | | Job: Run G-code with Confirmation |
+ | | Job: Start running | Begin running the control program code | | ||
+ | | Job: Stop running | Stop the control program | | ||
+ | | Job: Back to path | Run the back to path procedure - described [[mycnc: | ||
| Job: Skip forward | Move forward in the command program | | | Job: Skip forward | Move forward in the command program | | ||
| Job: Skip backward | Move backward in the command program | | | Job: Skip backward | Move backward in the command program | |
mycnc/wireless_pendants.txt · Last modified: 2022/08/19 15:22 by ivan