Differences

This shows you the differences between two versions of the page.

--- mycnc:wireless_pendants [2020/03/12 13:54] – ivan
+++ mycnc:wireless_pendants [2020/03/12 15:29] – ivan
@@ Line 1: / Line 1: @@
- =====Wireless Pendants=====
+=====Wireless Pendants=====
 Wireless pendants are currently sold in three configurations in the myCNC Shop.
@@ Line 38: / Line 38: @@
 | Job: Play 1 line | Run through a single command line (next line) |
 | Job: Play 1 line backwards | Run through a single command line (previous line) |
-| Job: Back to path | Run a predefined G-code command |
+| Job: Run G-code | Run a predefined G-code command (the command must be written out in the Message slot) |
-| Job: Back to path | Run a predefined G-code after confirming via a confirmation window.  |
+| Job: Run G-code with Confirmation | Run a predefined G-code after confirming via a confirmation window (the G-code command must be written out in the Message slot).  |
+| Job: Start running | Begin running the control program code  |
+| Job: Stop running | Stop the control program |
+| Job: Back to path | Run the back to path procedure - described [[mycnc:mycnc_configuration_dialogs#back_to_path|here]] |
 | Job: Skip forward | Move forward in the command program |
 | Job: Skip backward | Move backward in the command program |